In the Malcomizing heat treating process the passive oxide surface film of the stainless steel is broken down to permit nitrogen diffusion into the steel, at relatively low temperatures. This increases the Hardness to around 64-68 Rockwell C.

The blade diameter should be roughly 1/3rd the diameter of the vessel...

Most dispersion blades are formed from a circular disk of material, typically 304 stainless steel. Teeth are formed around the perimeter of the disk by cutting slits into the disk and bending the resulting tabs.

Beyond impeller bore configurations, with the Conn styles as well as other louvered or vented styles open area in the center of the impeller must also be considered. Typically, reinforcing discs, taper plates, sandwich the blade to stiffen the disperser disc. Due to the louver placement on the conn blade, the size of these disks, and with small sizes - the diameter of the mounting hub must be considered.

The design of a dispersion system begins by defining the batch size and product characteristics. From there we can begin to determine blade size, types, and number which will then allow us to define shaft rpm and horsepower requirements.

PACK EXPO Las Vegas and Healthcare Packaging EXPO are co-located shows at the Las Vegas Convention Center. Your badge allows you to move freely from one show to the other among the South, Central and North halls.

Inverters offer many benefits over traditional mechanical drives with fewer moving parts, larger speed ranges, broader horsepower range, and reduced maintenance.  But they do have limitations the largest of which is their torque characteristics.  sss

In commercial and industrial applications, voltages can be in excess of 1000kV.  Most equipment supplied by DisperseTech will operate at one of several common voltages 208, 240, 480, and 600 volts.  

Paint consists of four basic components: Resin Pigment Solvent Additives The performance of a coating is influenced by the selection of these components and the relationship between them. Several rations play an important function in the overall performance of a coating.

Mix Scale is used to quantify the mixing intensity needed for a given process as well as provide a frame of reference for mixing scale-up.

Blade Style, diameter, the material of construction, wear treatments need to be considered when ordering a dispersion baldes.  

Tanks are available in all shapes and sizes and fabricated out of a wide variety of materials. We offer small tanks for laboratory use through large storage tanks. Tank Designer calculates the volume of vertical and horizontal tanks allowing for different head types including dished, coned, and sloped bottom tanks.